INTERNATIONAL STANDARD ISO 6507-1:2018

Metallic materials — Vickers hardness test —

Part 1:

Test method

ISO 6507 consists of the following parts, under the general title Metallic materials —— Vickers hardness test:

ISO 6507-1 Metallic materials —— Vickers hardness test Part 1: Test method

ISO 6507-2 Metallic materials —— Vickers hardness test Part 2: Verification and calibration of testing machines and indenters

ISO 6507-3 Metallic materials —— Vickers hardness test Part 3: Calibration of refernce blocks

ISO 6507-4 Metallic materials —— Vickers hardness test Part 4: Table of hardness values

替代情況：替代ISO 6507-1：2005

Contents

Foreword 

1 Scope 

2 Normative references 

3 Terms and definitions 

4 Principle 

5 Symbols and designations

6 Testing machine

7 Test piece

8 Procedure 

9 Uncertainty of the results

10 Test report 

Annex A (normative) Minimum thickness of the test piece in relation to the test force and to the hardness 

Annex B (normative) Tables of correction factors for use in tests made on curved surfaces 

Annex C (normative) Procedure for periodic checking of the testing machine, diagonal measuring system and the indenter by the user

Annex D (informative) Uncertainty of the measured hardness values 

Annex E (informative) Vickers hardness measurement traceability 

Annex F (informative) CCM — Working group on hardness 

Annex G (informative) Adjustment of K?hler illumination systems 

Bibliography

1 Scope

This document specifies the Vickers hardness test method for the three different ranges of test force for metallic materials including hardmetals and other cemented carbides (see Table 1).

The Vickers hardness test is specified in this document for lengths of indentation diagonals between 0,020 mm and 1,400 mm. Using this method to determine Vickers hardness from smaller indentations is outside the scope of this document as results would suffer from large uncertainties due to the limitations of optical measurement and imperfections in tip geometry.

A periodic verification method is specified for routine checking of the testing machine in service by the user.

For specific materials and/or products, particular International Standards exist.

2 Normative references

The following docueare referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

ISO 6507-2:2017, Metallic materials — Vickers hardness test — Part 2: Verification and calibration of testing machines

ISO 6507-3, Metallic materials — Vickers hardness test — Part 3: Calibration of reference blocks

3 Terms and definitions

No terms and definitions are listed in this document.

ISO and IEC maintain terminological databases for use in standardization at the following addresses:

— IEC Electropedia: available at http://www.electropedia.org/

— ISO Online browsing platform: available at https://www.iso.org/obp